Board for Arduino

Mega 2560 R3 At Mega 2560-16au + Atmega16u2 + USB

Item No.: FUT6007
We produce this board based on the open-source official schematics.
The printing or color on the board may be different from each production date, but the function is exactly the same.
New features for Reversion 3 of the board has the following new features:
● 1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board. In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the Due that operate with 3.3V. The second one is a not connected pin, that is reserved for future purposes..
● Stronger RESET circuit.
● Atmega 16U2 replace the 8U2.

> This board is compatible with current boards and shields, but adds possibilities for new shields.
> The Mega 2560 is an update to the Mega
> The Mega2560 differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. It features the ATmega16U2 programmed as a USB-to-serial converter.

● Flash Memory: 256 KB of which 8 KB used by bootloader
● SRAM: 8 KB
● Clock Speed: 16 MHz
● Microcontroller: ATmega2560.
● Operating Voltage: 5V.
● Input:Voltage(recommended): 7-12V.
● Input Voltage (limits) : 6-20V.
● Digital I/O Pins: 54 (of which 15 provide PWM output)
● Input Pins: 16
● DC Current per I/O Pin: 40 mA
● DC Current for 3.3V Pin: 50 mA